Warning: file_put_contents(/www/wwwroot/www.1000114.com/index/temp_block/www.hotwtlz.com/ztdncbybhaaqptpuhtml.php): failed to open stream: No space left on device in /www/wwwroot/www.1000114.com/index.php on line 153
北原夏美好吗北原夏美好吗,藏娇by芍药藏娇by芍药

北原夏美好吗北原夏美好吗,藏娇by芍药藏娇by芍药

发布日期:2021年10月26日

Hi really need your help! 3inchx8inch joists @ 350mm centres ..18mm chipboard good for tiles

Discussion in 'Tilers' Talk' started by Johndiy1, Dec 23, 2020.

  1. Johndiy1

    Johndiy1 New Member

    Hi really need your help!

    Refurb project. joists replaced, they aren’t small at 3inchx8 inch @ 350mm centers. joists coveredwith 18mm tongue and grove chipboard.

    We are looking to cover 18mm chip with ditra mat or backer board. My question will the 18mm chipboard be ok with tiles. The entire flat will have tiles including the wet room.

    What would you go for ditra or backer taking into consideration the 18mm ply.

    18mm chipboard was picked, as it had the acoustic the membrane on the underside.

    Thanks for any help.
     
  2. Jord86

    Jord86 北原夏美好吗北原夏美好吗,藏娇by芍药藏娇by芍药Screwfix Select

    What do you mean, your post isn't clear. Will the tiles be ok on ditra mat/backer board on chipboard floor, or will the tiles be ok on just a chipboard floor? Where does 18mm ply come into it?
     
    Johndiy1 likes this.
  3. Johndiy1

    Johndiy1 New Member

    Hi Mate....Sorry ply should read chipboard i will amend the post.
    H
    will the tiles be ok on 18mm chipboard with either ditra mat or backboard. which would you guys recommended the back or ditra with the 18mm chipboard.
     
  4. Jord86

    Jord86 Screwfix Select

    Yes they will be ok on ditra mat, backer board or 9-12mm ply glued and screwed down to the chipboard, your choice really, just make sure you use a powdered flexible adhesive and separate flexible grout, and prime the surface with tile primer or SBR before tiling. There are adhesives suitable for tiling direct to chipboard but I don't know how good they are and what type of tile you are having which may affect the bond strength and longevity.
     
  5. Mr Rusty

    Mr Rusty Screwfix Select

    Personally I would swap a wet room for a low profile shower tray, but that's mainly because I hate wetrooms :D Also, I always think wetrooms are a problem waiting to happen. Otherwise agree with Jord 100%. For preference I would use Ditra over chip and a large area.
     
    Johndiy1 likes this.
  6. Johndiy1

    Johndiy1 New Member

    Many thanks for your advice all.
     
  7. Kas228

    Kas228 Active Member

    I agree with Mr Rusty, wet rooms will be a problem at some point whether immediately or in the future. Look great though.
     

Share This Page